One Sixth Warriors Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
82 Posts
Discussion Starter · #1 ·
I'm putting together various bashes involving Germans and Chinese. (Okay, so we're in very different theaters here!) I remember that Reasonable Collectibles used to have advice on how high the cuff titles should go, but I didn't write it down! So, if you were affixing LAH division cuff titles, how high above the cuff should they go?

Turning to Chinese division patches, any advice on how high/low one should put the 88th division patch or the Eighth Route Army patches?

Thanks for your help! ;)
 

·
Registered
Joined
·
83 Posts
Hi Trident
If not mistaken ,the wss wore their cuff bands 14cm up the sleeve so in 1/6 scale that should be more or less an inch, I usually align it with the bottom of the tunic's lower pocket flaps and do the same with left arm national eagle this time with the upper pocket flap.
 

·
Registered
Joined
·
82 Posts
Discussion Starter · #5 ·
Thanks, again.

According to another source I found, SS cuff titles were 15 cm above the end of the sleeve, which would translate to 2.5 cm in 1/6th scale.
 
1 - 5 of 5 Posts
Top