One Sixth Warriors Forum banner
1 - 8 of 8 Posts

·
sits in a loose parts box
Joined
·
7,448 Posts
I usually get rid of the PEQ Wires right away...i know they exist, but i havent seen anybody use it.
 

·
UMMM UMMM B17C#
Joined
·
8,816 Posts
I uses small guage craft wire and a small dremel bit.
 

·
wave man TDY staff
Joined
·
41,776 Posts
If your hobby shop doesn't have wire like Aaron's talking about, check out electronics outfits like Radio Shack, or dealers in the yellow pages.
 

·
UMMM UMMM B17C#
Joined
·
8,816 Posts
Or even check JoAnn or Michaels in the section where they have all of the beads for making necklaces and jewelry.
 

·
Registered
Joined
·
3,550 Posts
Palaboon said:
I usually get rid of the PEQ Wires right away...i know they exist, but i havent seen anybody use it.
Hey, that's good to know. I've been lucky and only managed to break one out of 6, but I was really stressed about it. If these things really are optional, I'll stop sweating it if it happens again. I may even rip 'em all off and get it out of the way. Either way, at least I know where to get replacements now. Thanks for posting this.
 

·
Uncle Sam's Trunk Monkey
Joined
·
873 Posts
Just FYI the PEQ 2's have a button on top of it to turn it on when the preasure pad fails to work
 
1 - 8 of 8 Posts
Top