One Sixth Warriors Forum banner
1 - 4 of 4 Posts

· I got you "covered" ! (OSW Staff)
Joined
·
5,289 Posts
Discussion Starter · #1 ·
Here are the directions for installing the FRONT BRUSHGGUARD:

REMOVE any raised areas or blemishishes from the existing front end and SAND SMOOTH:



USING PLASTRUCT PLASTIC WELD .....center and glue the supplied BACKPLATE:




SET ASIDE to dry completely.
After the glue has dried, Take the new FRONT END and glue it to the backplate: This is what it will look like if you choose not to have the brushguard on :



To put the Brushguard on use the 2 brackets and secure them to the Brushguard and the front end with the pins in the top holes and the Bolts in the bottom.




Drive carefully.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top