One Sixth Warriors Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4,097 Posts
Discussion Starter · #1 ·
I don't own a Dremel tool but I would wondering about how to shave a head to a high and tight or a more closely cropped hairstyle. I have a few HS that I want to update and repaint mainly : Rick, Rob Deniro, and Leopold that I would like to give closer cropped heads without weakening the the sculpt wall. Has anyone done this on their HS before?
 

·
Alba Supporter! (Staff)
Joined
·
2,555 Posts
Thats a tough one because most of the molded HS's aren't too sturdy if you give em a haircut. I tried this an almost lost an extremely rare HS, it got paper thin after getting most of the hair off and even then it was still a bit higher than the rest of the "skull". But, there is a posibility to do high and tights on resin HS's, but that would involve lots of sanding or buying a Dremel. I did it to a Frontline sculpt and it turned out great! Hope this helps
 
1 - 3 of 3 Posts
Top