One Sixth Warriors Forum banner
1 - 2 of 2 Posts

·
Zombie Slayer 1st Class
Joined
·
231 Posts
Discussion Starter · #1 ·
Ok, I ordered some Apoxie Sculpt and am planning on doing some mods to a couple of headsculpts. I have a couple of questions though.

#1-do I need to strip the paint off of the headsculpt before adding beards or other mods?
#2-if so, what should I use to remove the existing paint?
#3-once cured, can I paint directly over the Apoxie or do I need to seal it first?

Thanks
 

·
DO NOT READ THIS SENTENCE
Joined
·
2,235 Posts
I personally havent done this but i know how.
#1-I would remove the paint and also scratch into the area your added the sculpt so it has somethin to bit into and stay on better.
#2-Try using water,simple but sometimes its all you need. Or use white spirit mixed with water.
#3-I'd put a base cost on with an everyday base coat paint

Hope this helps
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top