[dedguy]

So I did some searches but couldn't find anything on this. I have a lot of DID hands laying around and was wondering if anyone had tried converting them. My only experience previous was Sideshow hands, which where easy to do as they where gloves. Just hand to make the existing hole larger. The DID hands look like I could just cut off the hinge and dremel them out. I would think I'd need to use some sort of round bit to make the cavity for the ball to fit into. Any advice on the subject would be helpful.

 

[KneeJoint]

Sorry man, I wish I had something helpful to add. I will be rooting for you as I am in the same boat.

best of luck with a bear of a project.

 

[dedguy]

It shouldn't be that hard, assuming I have the right bits to do it. May try it this weekend.