One Sixth Warriors Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter · #1 ·
Hello!

Thanks for looking at the thread, I'm wondering what the best way to cut a hole for the shoulder board screw would be on Alert Line's DAK set, I purchased a few and none have holes pre cut for the boards, I was considering using an exacto knife to punch holes but didn't want to cause a larger tear in the uniform.

Anybody have a solution?

Thanks,
Justin
 

·
WWII Guy
Joined
·
1,418 Posts
The exacto knife method is going to be the way forward. Just be minimalist with the "cutting " part and all will be fine.

Cya
Hankster
 
1 - 2 of 2 Posts
Top