One Sixth Warriors Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1,115 Posts
Discussion Starter · #1 ·
Hi,
I have resin cast head.

I want to add a SCULPEY beard

If it was a commercial vinyl head I would probably play it safe and just dip in a cup of boiling water.

if I mold the sculpey beard on the resin head, can I put the whole thing in the oven without damaging anything ?

Any advice would be appreciated.

Thanks

Jim
 

·
Captain Eyestrain
Joined
·
1,195 Posts
Yes , but make sure you have a good temperature control on the oven. If you can keep the temperature at around 125C , you should have no problem at all . Very straightforward, and actually safer than doing it on a vinyl head.
 
1 - 3 of 3 Posts
Top