Making a Diemaco - a question [Archive] - OSW: One Sixth Warrior Forum

View Full Version : Making a Diemaco - a question



Scaley
02-27-2007, 14:22
I want to make a couple of Diemaco variants. How much would it take to make one from a stock M4?

The major difference as far as I can see is the barrel - most other detail would be lost at this scale. Anyone got any hints/ tips/ ideas?

Also which would be the best donor, DML or BBI etc and which version (there's a lot out there)

Thanks.

Paladin
02-28-2007, 17:35
Which variant are you trying to built? C8 Carbine? Id use a DML XM177, cut off the barrel, and add a DML M16A2 barrel.

Scaley
03-01-2007, 17:10
http://www.diemaco.com/sfw-page.htm is what I'm after.

I'm thinking BBI M4 and some inventiveness as regards the barrel...

grizzerr
03-01-2007, 19:04
http://www.diemaco.com/sfw-page.htm is what I'm after.

I'm thinking BBI M4 and some inventiveness as regards the barrel...

All it is is a mod M4 and the barrel would be easy to change/mod.

Broadshore
03-02-2007, 00:34
Something like this????

C7A1 Short Barrel.
https://www.onesixthwarriors.com/photo/data/503/DSC01070.jpg

Scaley
03-02-2007, 06:54
Very nice that, what did you use as the donor weapon?

Broadshore
03-02-2007, 13:14
Pretty much I took a old Plastic version <not the metal> M16A4 from BBI, Shorten down the barrel using a X-Acto Saw. Then use a small piece metal rod piece between the Flashhider and Barrel. Zap them tow piece together. Next, I took the the old stock from 21st Century Mk48 SEAL LMG. Cut off the old Soild stock and attached the Slither Stock. Did the same thing, made a small pin then glue the stock to the receiver.

The Mag is made with Styrene. Kinda forgotten What I used to make it.

Scaley
03-03-2007, 08:02
Many thanks for the tips matey.

Broadshore
03-03-2007, 14:03
No problem, I wish I had another M16 laying around and I can show you a step to step photo of the project.

justin_g
07-12-2007, 10:28
Note the features listed on the Diemaco site for the SFW - as far as I can tell these are the major ones that differ from the M4:

1. 16" heavy barrel
5. Rail on left side of sight block
10. Sling loop at rear of receiver
11. Rubber butt pad on stock

Here's what I have thought up as possible methods(just some ideas, I haven't tried them yet!):

1. Replace barrel with 16" custom one - either cut up another rifle barrel or use styrene tubing - then use a couple of sections of heat-shrink tube to get the different thickness profile.

5. Use a DML side sling mount(came on some of their M4s) - cut off the sling swivel and glue on a piece of rail.

10. Styrene sheet trimmed to shape I guess(or just ignore it).

11. Cheat - use the new TS M4(90's Ranger Mullen), it has a rubber butt pad already!