X26 Taser [Archive] - OSW: One Sixth Warrior Forum

View Full Version : X26 Taser

02-23-2007, 01:03
Anyone here ever gave making one an attempt?

I'm going to start getting the things I need for my Warrant Task Force project, and I'll be needing a Taser. Any recommendations? My mom has been making things with Sculpty for ages, time for me to give it a shot. Does one already exist with a figure out there somewhere? I've searched and came up with nothing.

02-23-2007, 07:37
I have done one. Reggie from this board did a Timecop gun cast. I then took this cast and adapted it a bit with some filling and produced this! With a lick of paint and not too much close attention it passes for a taser. I made 3, Joe on this board has the other two.

02-25-2007, 07:50

Let me know if you need any measurements or pics. I have a few X's laying around. I think sculpting is going to be your best bet, none have been made in 1/6th.

I do have a sort of lapel pin that I got at the IACP convention a couple of years back with the launch of the X-26. But I think it is too big.