Advice: Sculpey + resin + baking ??? [Archive] - OSW: One Sixth Warrior Forum

View Full Version : Advice: Sculpey + resin + baking ???

Jimmy C
05-16-2009, 15:37
I have resin cast head.

I want to add a SCULPEY beard

If it was a commercial vinyl head I would probably play it safe and just dip in a cup of boiling water.

if I mold the sculpey beard on the resin head, can I put the whole thing in the oven without damaging anything ?

Any advice would be appreciated.



Tony Barton
05-17-2009, 12:45
Yes , but make sure you have a good temperature control on the oven. If you can keep the temperature at around 125C , you should have no problem at all . Very straightforward, and actually safer than doing it on a vinyl head.

Jimmy C
05-17-2009, 15:16
Thank you Tony